GMPP Serpentine Accessory Drive System, With A/C
Use RUS648060 Russell fitting for power steering outlet.
Note: Drive system will not bolt to Production Cast Iron Blocks
If using a RUS648060 16mm X1.5mm O-ring adapter on the power steering pump in this kit, approximately .060" will need to be machined off of the back face of the pulley to clear the adapter fitting. The pump will supply 2 gallons per minute @ 1640/1740 PSI
The A/C compressor in this kit is a Denso 10S17F
Serpentine System without Air
Passenger side top mount add on A/C Package
Alternator connector and pigtail
A/C Compressor connector and pigtail
Power Steering Pump to -6 AN Male Adapter Fitting
LS3 Harmonic Balancer for use with 19155066 Serp System
ARP HD Balancer bolt and washer kit
Reviewed by: David08/18/2013 09:46PM
Product ownership: Less than 1 year
Purchased from: Pace Performance
All parts fit my new LS3 engine, but don't buy this drive for use on any street rod using a mustang II style suspension with rack and pinion steering. The alternator sits about an inch from the steering shaft on the rack and won't work.
The corvette style serpentine drive places the alternator too far from the engine centerline to work with cars '40 and older - the engine compartment is just too narrow.
You must login to post a review.